Starting and Exiting the Flow Engine

The Flow Engine runs on PCs and workstations. Use the following procedures to start and exit the Design Manager.

Starting from the Alliance Series

To launch the Flow Engine from the Alliance Design Manager, select an implementation revision and do one of the following.

• Select Tools Flow Engine.
  
  
• Click the Flow Engine toolbox button, shown in the following figure.
  
  
  
  

Starting from the Foundation Series

To launch the Flow Engine from the Foundation Project Manager, select the Implementation phase button on the project flow chart, shown in the following figure.

Note: For more information about accessing and using the Flow Engine from the Foundation Project Manager, see the “Design Implementation” chapter of the Foundation Series User Guide.

Exiting the Flow Engine

To exit the Flow Engine, select the Flow Close command.