|
|
|
|
|
The ProratingOptions command controls temperature and voltage prorating.
This command is equivalent to the Options 
Prorating Options menu command.
The syntax of the ProratingOptions command is the following.
ProratingOptions [Temp [degrees_celsius]] [Volts [voltage]]
degrees_celsius is the temperature prorating.
voltage is the voltage prorating.
If no value is specified for the temperature or voltage, the prorating is set to the worst case value.
You can abbreviate the ProratingOptions command syntax as follows.
po [T [degrees_celsius]] [V [voltage]]
Following are examples of the ProratingOptions command.
po
po t
po t 80 v 5.2