|
|
|
|
|
The DelayLessThan command specifies a maximum delay in nanoseconds. This command only supports analysis of CPLD designs. The Timing Analyzer reports only those paths that have a delay less than or equal to the specified value. By default, the Timing Analyzer reports all paths regardless of their delay.
This command is equivalent to the Report Delays Less Than option in the Report Options dialog box, which is activated by the Options 
Report Options menu command.
The syntax of the DelayLessThan command is the following.
DelayLessThan delay_value
Delay_value is the maximum delay in nanoseconds. It is optional. If a value is not specified, the limit is turned Off.
Abbreviate the DelayLessThan command syntax as follows.
dl delay_value
Following is an example of the DelayLessThan command.
delaylessthan 30