Previous

IFDXI

Input D Flip-Flop with Clock Enable (Asynchronous Preset)

XC3000
XC4000E
XC4000X
XC5200
XC9000
Spartan
SpartanXL
Virtex
N/A
Primitive
Primitive
N/A
N/A
Primitive
Primitive
Macro

figures/x6016n.gif

The IFDXI D-type flip-flop is contained in an input/output block (IOB). The input (D) of the flip-flop is connected to an IPAD or an IOPAD. The D input provides data input for the flip-flop, which synchronizes data entering the chip. The data on input D is loaded into the flip-flop during the Low-to-High clock (C) transition and appears at the output (Q). The clock input can be driven by internal logic or through another external pin. When the CE pin is Low, the output (Q) does not change.

The flip-flop is asynchronously preset with High output, when power is applied. FPGAs simulate power-on when global set/reset (GSR) is active. GSR (XC4000, Spartans) default to active-High but can be inverted by adding an inverter in front of the GSR input of the STARTUP symbol.

For information on legal IFDXI, IFDXI_1, ILDXI, and ILDXI_1 combinations, refer to the “ILDXI” section.

Inputs
Outputs
CE
D
C
Q
1
D

d
0
X
X
No Chg
d = state of D input one setup time prior to active clock transition

Figure 6.18 IFDXI Implementation Virtex

Next