OnlyLongestPaths

The OnlyLongestPaths command restricts the Timing Analyzer to reporting only the path with the longest delay, if there is more than one path between two end points. It only supports analysis of CPLD designs. By default, the Timing Analyzer reports all paths.

This command is equivalent to the Report Only Longest Paths Between Points check box in the Report Options dialog box, which is activated by the Options Report Options menu command.

Syntax

The syntax of the OnlyLongestPaths command is the following.

OnlyLongestPaths {true|false}

• True includes only the longest paths; it is the default when you generate the Advanced Design Analysis report.
  
  
• False includes all paths; it is the default when you generate any report except the Advanced Design Analysis report.
  
  

Abbreviation

Abbreviate the OnlyLongestPaths command syntax as follows.

olp {t|f}

Example

Following is an example of the OnlyLongestPaths command.

onlylongestpaths false