XC4000 Implementation Options

Click the Translate, Optimize and Map, Place and Route, or Timing Reports tab to access the different options within the Implementation Options dialog box. These options affect the Translate, Map, and Place&Route steps in the implementation flow. Use the different tabs of this dialog box to set the options described in the following sections.

Click OK to accept the options, click Cancel to exit the dialog box without changing any settings, click Default to set the default options, or click Help to obtain online help.

XC4000 Translate Tab

Use this tab, shown in the following figure, to set the translate options.

Figure 5.42 XC4000 Translate Tab

The XC4000 Translate tab is identical to the tab described in the “Spartan Translate Tab” section.

XC4000 Optimize and Map Tab

Use this tab, shown in the following figure, to set the optimize and map options.

Figure 5.43 XC4000 Optimize and Map Tab

The XC4000 Optimize and Map tab is identical to the tab described in the “Spartan Optimize and Map Tab” section.

XC4000 Place and Route Tab

Use this tab, shown in the following figure, to set the place and route options.

Figure 5.44 XC4000 Place and Route Tab

The XC4000 Place and Route tab is identical to the tab described in the “Spartan Place and Route Tab” section.

XC4000 Timing Reports Tab

Use this tab, shown in the following figure, to set the timing reports options.

Figure 5.45 XC4000 Timing Reports Tab

The XC4000 Timing Reports tab is identical to the tab described in the “Spartan Timing Reports Tab” section.