ShowSettings

The ShowSettings command lists all the current settings for Timing Analyzer options. You can save the contents of the window as a macro or a report.

This command is equivalent to the View Settings menu command.

Syntax

The syntax of the ShowSettings command is the following.

ShowSettings [save file_name]

The report appears in a pop-up window.

• Save indicates that you can optionally save the Show Settings report in a file.
  
  
• File_name is the name of the saved file. You can add a .xtm extension to the file_name to save the settings as a macro to return the system to the same state as when the settings were saved. See the “Saving a New Macro” section and the “Running a Macro” section of the “Using the Timing Analyzer” chapter for more information.
  
  

Optionally, you can add a .twr extension to the file_name to save the settings as a report. TWR files are listed as Timing Analysis Reports (*.twr) under List Files of Type in File menu command dialog boxes. See the “Saving a Report” section of the “Using the Timing Analyzer” chapter for the procedure to save a report.

Abbreviation

You can abbreviate the ShowSettings command syntax as follows.

ss [s file_name.xtm]

Example

Following is an example of the ShowSettings command.

showsettings save triad2.xtm